Eurovan2 Forums - View Single Post - 2.2 hdi Blocked diesel filter message ECU faulty???

printertosh · 7th July 2009, 16:33

Thanks very much for the information Luc C5. I took the sensor off the car today and connected +5v to pin 3 and -v to pin 2. Voltage tester showed 1.7v from pin 1 so that confirms that the sensor was damaged by the water in the pipes. I've ordered the new parts for £65.00 including VAT for Sensor, Bracket, Pipes and 4 Clips. Peugeot say that it has been modified, I presume to stop the water problem. I read somewhere that the sensor is placed at a different angle on the newer Peugeots to prevent this. I will post some photos on here if it is different to the original so people can see the modification. Thanks again. Paul

7th July 2009, 16:33	#6 (permalink)
printertosh Fledgling Join Date: 23 Dec 2008 Location: England Age: 37 Posts: 15 Thanks: 7 Thanked 2 Times in 2 Posts Car: Peugeot 807 Country of origin:	Thanks very much for the information Luc C5. I took the sensor off the car today and connected +5v to pin 3 and -v to pin 2. Voltage tester showed 1.7v from pin 1 so that confirms that the sensor was damaged by the water in the pipes. I've ordered the new parts for £65.00 including VAT for Sensor, Bracket, Pipes and 4 Clips. Peugeot say that it has been modified, I presume to stop the water problem. I read somewhere that the sensor is placed at a different angle on the newer Peugeots to prevent this. I will post some photos on here if it is different to the original so people can see the modification. Thanks again. Paul
printertosh is offline